President of the Russian Federation V.V. Putin held a meeting in PJSC “Rosseti” on electric power industry development

 

 

Round-table meeting of the State Duma Committee on Energy

 

 

The decision is commented by E.P. Grabchak, Director of the Department for Operational Control and Management in the Electric Power Industry of RF Ministry of Energy

 

 

Interview with G.I. Meshchanov, Director General of VNIIKP

 

 

PLC Technology, LLC

 

 

Pazderin A.A. (MES of Ural, branch of PJSC “FGC UES”)

 

The paper presents power cost distribution model, connecting power flows throughout electrical network with transmission cost. The model allows to distribute the full cost of transmission services between the nodes of electric power supply taking into account power losses and utilization factor of electrical network equipment. It gives a possibility to assess nodal transmission tariffs which are proportional to the costs covered by utilities. The presented model makes it possible to determine nodal factors of relative profitability characterizing the economic efficiency of power transmission for various nodes of electrical network.

power cost distribution, transmission tariff, tariff formation, energy flow, cost flow, element costs, nodal tariffs, nodal factors of relative profitability

 

Interview with V.A. Borisenkov, Director General of JSC “MSK Energo”

 

PJSC “MOESK”

 

 

Interview with E.V. Lyapunov, First Deputy Director General, Chief Engineer of the branch of PJSC “FGC UES” – MES of Center

 

Krongauz D.E. (Krasnoyarskenergo, Branch of PJSC “IDGC of Siberia”)

 

. The possibility of improving of damage accounting caused by power interruptions is considered.

: power supply, damage, consumers, power supply reliability

 

PJSC “MOESK”

 

 

Interview with N.A. Karasev, CEO of “Forenergo”

 

 

Levin V.E., Kozhevnikov A.N. (NSTU), Safonov O.N. (PJSC “TDC”)

 

Power transmission is carried out mainly through overhead transmission lines. According to operational practices, there are not only cases of conductors destruction, but also situations when transmission line supports are damaged. The paper provides a brief literature review related to design and calculation of overhead power lines, conductors and separate power line segments.

transmission lines, conductor, structural design, strength calculation, mathematical model

“PLP RUS”, LLC

 

 

Kuchumov L.A., Kuznetsov A.A., Evdokunin G.A., Titenkov S.S., Nazarychev A.N., Milyutin S.I., Chervochkov D.P., Sukhodoev S.P. (CJSC “ENERGOSOYUZ”, SPbPU, FGAOU DPO “PEIPK”, PJSC “Lenenergo”)

 

The paper considers particular features of single-phase earth faults in 10 kV electrical network with low-resistance neutral grounding. Calculated and experimental data of operating conditions within metallic earth faults experiments under isolated and resistive neutral are compared.

isolated neutral, resistance earthed neutral, single-phase earth fault currents, oscillograph recording

 

Dmitriev M.V. (St. Petersburg Polytechnical University)

 

. Personal safety while working on discharged overhead lines under induced voltage is studied pretty well. However, it is impossible to say the same about 6-500 kV cable lines, where induced voltage is a total surprise very often. The paper presents a number of examples demonstrated the process of induced voltage occurrence on discharged cable line caused by closely-spaced energized cable or overhead lines.

: overhead line, cable line, single-phase cable, magnetic field, induced voltage, personal safety

 

JSC “Sverdlovsk Plant of Current Transformers”

 

CJSC “Polimer-Apparat”

 

 

Rosneft Oil Company

 

 

Interview with N.S. Efimov, CEO of “NPP Bresler”, LLC

 

 

JSC “RTSoft”

 

 

PJSC “IDGC of North-West”

 

 

“SKB EP”, LLC

 

 

Titov D.E., Volkhov K.V., Kudryavtsev A.A., Kotolivtsev V.V., Petrenko S.A.

 

The paper presents the results of studies for determining the impact of dew, fog, rain, pollution and insulators lifetime on discharge voltage, ohmic resistance, amplitude of the leakage current sinusoidal component, partial and corona discharges pulses, mechanical strength and voltage distribution over string of insulators. Obtained results can be used in the development of risk-oriented control technologies for line insulation.

insulator, flashover risk, line isolation, hardware diagnostics, breakdown indication device, insulator string

 

Interview with A.V. Laptev, CEO of CJSC “Intera”

 

 

Russian Federal Service for Ecological, Technical and Atomic Supervision

 

 

Peoples’ Friendship University of Russia

 

 

“SO UPS”, JSC

 

 

To the 90th anniversary of “Isolator” plant director A.A. Barkov